Micro-Air EasyStart


EasyStart™ 366 Soft Starter (board-only)

EasyStart™ is a one-of-a-kind, custom-developed soft starter for single-phase motors. It can support both 115 and 230VAC motors. It employs a 4-part start ramp sequence that is self-optimising, resulting in the lowest possible start-up current. EasyStart can deliver up to 75% start current reduction as compared to a compressor's LRA (locked-rotor amperage). It also has numerous specialised fault checks not found in any other soft starter to provide further protection for your compressor.

EasyStart is the perfect solution that allows an air conditioner or refrigeration compressor to operate on a generator, inverter, or limited utility power when it would otherwise not have functioned. It can also be applied to air compressor and fluid pump motors.

The EasyStart 366 is available in two models. The X05 model is capable of supporting up to a 36000 BTU ( 3 ton) compressor. The X06 model is capable of supporting up to a 72000 BTU (6 ton) compressor. The start capacitor and enclosure are not included (board-only), thus providing a substantial cost savings, but they must be provided by the installer..

EasyStart™ The most advanced & effective soft starter for all A/C applications

• Start Your A/C With-Out Buying A Second or Bigger Generator or Inverter

• Run 2 Air Conditioners On A 30- Amp Cord

• Sleep, with less noise, And Cool All Through The Night

• Run Your A/C with more Appliances At The Same Time

• Board dimensions: 5.45in/138mm x 3.35in/85mm


Start Capacitors for EasyStart™ 366

EasyStart™ 366 requires that you wire in your own compressor start capacitor. The values required are described in the table below.

Recommended Start Capacitors:

– Up to 12kBTU 72-86MFD
– 13-23kBTU 88-106MFD
– 24-36kBTU 108-130MFD
– 37-48kBTU 189-227MFD
– 49-72kBTU 270-324MFD

115VAC applications can use 250V or 330V rated start capacitors.

230VAC applications must use 330V rated start capacitors.

Compressor Triac Replacement Relay

When used with a high-current triac that controls the compressor switching, EasyStart requires that the triac be replaced with a power relay. This replacement relay is design with mounting that matches the footprint of the Sanrex® TG35F40 triac, commonly used in marine air conditioners.

The relay comes with two nylon standoffs and two screws for mounting in the same stud locations as the triac.

Download the full resolution flyers below...

EasyStart - Information


EasyStart - Performance


EasyStart - Reviews


Contact form...


Latest Tech Sheets

Use the buttons at the bottom of the panel, drag the scroller on the left edge of the panel or simply use your mouse to scroll through the information below.

EasyStart Documentation

Information Sheet - Download

Performance Sheet - Download

Visit the Product details page -

EasyTouch Documentation

Operation Manual - Download


How to find us...

Gold Coast, Queensland,

Gary Kennedy (M): 0448 882 056